Wrap Buddies® were born in 2008 after Bret Wortman became frustrated during a gift wrapping session when his rolls of wrap kept falling on the floor, and wrapping on the floor hurt his knees and back too much. The first Buddies were made of wood and fit one tabletop precisely, with no adjustability.
Several years later, the 3D printing revolution made it possible to prototype designs that adapted to multiple table thicknesses, and we were off to the races!
We soon incorporated a tape dispenser too on each end to eliminate the search for the elusive tape problem and suddenly, gift wrapping was fun again.
HOW IT WORKS
Clip Wrap Buddies to any table or counter top. Place the roll in between the Wrap Buddies and adjust the spacing to fit the length. Unroll the paper, measure, and easily cut. The built in tape dispenser stays close by so everything you need is always within reach.